-
Similar Content
-
Recently Browsing
- No registered users viewing this page.
-
Topics
-
Posts
-
By watchweasol · Posted
Hi could be from a favorite jeweling tool. I have one but not checked the holders . Probably worth doing sometime though. -
By watchweasol · Posted
As stated by Neven and Hector, the tool generates an alternating wave form which pulses the rotor. With the coil off and the circuit block off it will spin the rotor. For an understanding of how quartz watches work read the attached documents. a cheap line release tool can be made from a low voltage transformer or a mains transformer the active ingredient being the generated wave form. Introduce the watch and the wave form acts on the rotor ElectricWatchRepairManual.pdf Witschi Training Course.pdf -
Should I heat and temper the graver after I’ve got a good edge?
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.