Looking for Rubber Washers/Gasket for Panerai
-
Recently Browsing
- No registered users viewing this page.
-
Topics
-
-
Posts
-
Welcome to the WRT forum and good luck with your forey into horology. -
Hi all, I'm in the position to take over a Boley lathe. It's 8mm with a cross-slide and faceplate I wanted. Apart from making balance staffs and winding stems, an important goal would be repivotting and drilling out worn pivot holes to rebush (oval ones making round again). There is however no tailstock included with drillchuck or even just one with simple collets. What are my options? As it's also no WW, finding compatible tailstock will be next to impossible (and then there is the problem with alignment). I know there are people doing it freehand but as a novice with not to steady hands (understatement) this seems extremely difficult. It would be used for wristwatches and clocks. Kind regards -
By RichardHarris123 · Posted
Hello and welcome from Leeds, England. -
No name punched on the stakes? Maybe WELO , a German brand. Frank -
Hi to you all. I’m a doctor (thoracic surgeon) at work. A mechanic enthusiast at heart.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.