Which Watch Have You Got Coming In The Mail ? Show Us !!!
-
Recently Browsing
- No registered users viewing this page.
-
Topics
-
Posts
-
Mark posted this video - which might explain what your are seeing in an extreme case
-
I would add that depending on how tall the seconds hand pinion is, this could also be 105 or 106 to accommodate the extra height of a calendar complication. But I don't know how those were packaged, especially since this does not include the dial rest plate. Those would have different dial plates and you don't seem to have any at all.
-
By watchweasol · Posted
Hi was the watch running before the service ? Because the symptoms you describe would point to lack of end-shake on the balance staff. Best to power down the movement remove the fork and try the balance on its own using a blower to power the balance, it should rotate for some time quite freely. -
By watchweasol · Posted
Hi. Run a little wd40 under the screw around the flange and leave it for a while then re try. If it’s just turning on a bad thread put a screwdriver under the flange and apply a little pressure upwards and unscrew whilst under pressure -
Does this happen both with and without the fork? Photos of what you've mentioned would help.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.