Jump to content

Yt57B

nitram55
 Share

Recommended Posts

nitram55 New Member

nitram55

Posted
Posted

Hi All
I have to replace the crystal in a lorus kinetic with the above movement and I cannot figure how to remove the stem, I have looked for the usual detent button lever ect but to no avail any help would be greatly appreciated.

yt57b2_zps52497602.jpg

Thanks

Martin

Blacklab Distinguished Member

Blacklab

Posted
Posted

post-80-0-27759800-1400181788_thumb.jpg

 

I think this is the setting lever (arrowed) try depressing it with a sharpened pegwood (and not by calling it names). If that don't work can you post the same photo again but with the crown pulled out to the setting position.

  • Like 2
nitram55 New Member

nitram55

Posted
  • Author
Posted

Thanks Blacklab

 

When the crown was pulled out to the first position a lever was exposed behind the setting lever, depressing this did the trick.

Thanks again for replying.

Martin

 Share
Go to topic listing

  • Recently Browsing

    • No registered users viewing this page.

  • Topics

  • Posts

    • Mercurial
      Phinney Walker Mickey Mouse Watch HELP

      By Mercurial · Posted

      I have no experience with this watch, but looking at the pictures from the ebay listing linked above, it looks like the outer metal bezel at the back of the watch may not be part of the case proper.  It looks like the watch and strap are sandwiched together, and an inner case may push out of the rear bezel towards the front of the watch.  A case style similar to the Roamer watches where the crystal, movement and caseback pushed out through the back of an outer bezel, only in reverse - this one may push out towards the front.  To test this, you would need to hold the watch, dial down, supporting the dial side of the watch around the edge of the bezel without touching the bezel itself. Then push down carefully on the inner metal ring you can see at the back of the watch. I’m speculating here, proceed at your own risk. Hopefully someone with hands on experience of these watches can chime in! Best Regards, Mark
    • VWatchie
      Ad Free WRT

      By VWatchie · Posted

      Thanks, Mark. That's the kind of reassurance many of us wanted to hear! Yes, life is unfortunately unpredictable, and it would be a shame if the many dedicated WRT: ers became stranded if, god forbid, something happened to you and WRT stopped working.
    • Kalanag
      Tissot case back removal

      By Kalanag · Posted

      The case back is perfectly aligned to the case and has no provisions for a screwing tool. The T-Sport series has snap on backs.
    • AndyGSi
      Tissot case back removal

      By AndyGSi · Posted

      For me the text looks too aligned and with no obvious way to grip as a screw back.
    • bosstaki
      Tissot case back removal

      By bosstaki · Posted

      There’s no indents & there’s no little groove to pry it off anywhere! So I don’t know if it’s screw down or pry off 👍
×
×
  • Create New...